- Transmission Stop Off Tool
- This tool fits most domestic rear wheel drive cars and light trucks, eliminating the draining of fluid when servicing the drive line or replacing universal joints
- 1.30-in thru 1.45-in diameter.
- No need to drain the transmission fluid when making repairs or replacing drive shaft U-joints
- The tool plugs the transmission drive shaft opening
- Reduces fluid waste and with a lot less mess


Frete Grátis em todo o BrasilProduto Original Importado dos EUA
Powerbuilt 940376 Transmission Stop-Off Tool , Red
*$348.20
Informação adicional
Manufacturer | All Trade Tools |
---|---|
Brand | Powerbuilt |
Model | Transmission Stop-Off Tool |
Item Weight | 3.36 ounces |
Product Dimensions | 8.63 x 3.88 x 2 inches |
Country of Origin | China |
Item model number | 940376 |
Manufacturer Part Number | 940376 |
Date First Available | January 22, 2011 |
Robert –
Worked perfectly for what I needed to
Jason Martin –
Worked perfectly
CS –
I used this on an A833- 4 speed. Fitment was good. It did not leak. It’s easy to use and is of good quality.
Amazon Customer –
This works great on my 4L80E transmission. I had a few quarts of fluid in the transmission when I installed it into my car attached to the engine. So, it was tilted with the tail of the transmission pointed down for quite a while, and there was no evidence of any leakage during installation.
Omar Soto –
one side of this fits the output shaft of my M20 Muncie 4 speed . No leaky leaky.
Just use some Duct tape to keep it in place.
Kenneth l. Welch –
I had to remove a transmission to replace a clutch. This allowed me to save the transmission fluid from leaking out. Its cost effective as well compared to the amount of transmission fluid you’ll need to replace if drained.
Robert –
This fits my 2013 silverado 5.3l 6l80 2wd great it fits in there snugg. I lost a minimal amount of Trans fluid maby a 1/3 of a cup. This tool is very inexpensive and a money saver. I recomend this product.
BillB –
Used it to pull my TKX out of my 54 F100 restomod. Only time any fluid dripped out was when I hit the end on the drive shaft loop. Used some Gorilla tape to hold it in place and it didn’t move again and didn’t leak.
cynthia orozco –
Worked for 4l60e trans..no leakes.
B.N. –
Used it on a 4L65E transmission and no leaks!