- Knock Sensor Extension Wiring Harness
- Fits LS1 / LS6 to LS2 Conversion Adapter
- Works on single wire knock sensors only
- QTY 1 harness


Frete Grátis em todo o BrasilProduto Original Importado dos EUA
Knock Sensor Extension Wiring Harness Fits LS1 / LS6 to LS2 Conversion Adapter
*$325.00
Informação adicional
Manufacturer | 269 Motorsports |
---|---|
Brand | 269 Motorsports |
Item Weight | 1.58 ounces |
Package Dimensions | 9.21 x 7.99 x 0.98 inches |
Item model number | HAR-006 |
Is Discontinued By Manufacturer | No |
Manufacturer Part Number | 18200 |
Date First Available | April 17, 2016 |
Sharon hernandez –
The connectors that plug onto the stock knock sensors do not plug in. The knock sensors have a male terminal, so you need a female terminal on the harness, these plugs have a male terminal.
Manuel –
Needed for gen 3 to gen 4 Ls swap
aldo –
Make sure when u intalled dont put it to close to a hot part on ur engine it burns quickly
Barry Bain –
Exactly what I needed.
Tom C. –
Had issues with bank 1 knock sensor not reading well and didn’t want to pull the intake. Relocated bank 1 knock sensor to back side of bank 1 head and used this harness to connect to that 1 sensor.
Gary R. Peterson –
Finally a way to relocate my knock sensors to the sides of the block (like the post 2007 LS production) instead of the horrible job of removing the entire intake manifold and associated paraphernalia (pretty much the entire top of the engine). Then hope the new sensors don’t fail anytime soon as they’re in a location that almost ensures failure again.
Big Daddy –
Relocated the knock sensors on a 2004 Tahoe throwing a knock sensor code. Used two new ACDelco sensors and this relocation harness. Just left old harness in place but unhooked. Took care of my knock sensor problem.