Frete Grátis em todos os produtos
- Fit model :for TRAXXAS-1/5 X-MAXX 8S medium carbon steel large tooth shaft support and high speed bearing three point support TXM8035/TR.
- Made of medium carbon steel, wear resistant, strong and easy to use.
- Replace the damaged parts to provide better working performance.
- The stability and transmission effect are better than the original two-point support.
- Package includes: big tooth shaft support and high speed bearing three point support.
Valvoline Multi-Vehicle (TCF) Conventional Transfer Case Fluid 1 QT, Case of 6
*$722.30
JAVIK Front Prop Shaft Yoke & U-Joint (2 Side) for Polaris Ranger 400 500 570 700 800 900 1000 Diesel HST ETX
*$625.00
Frete Grátis em todo o BrasilProduto Original Importado dos EUA
Gear Shaft Bracket and High-Speed Bearing Three-Point Support Fit for TRAXXAS-1/5 X-MAXX 8S Medium Carbon Steel Driveshaft TXM8035/TR
*$430.70
Informação adicional
| Package Dimensions | 4.88 x 4.76 x 0.79 inches, 1.06 ounces |
|---|---|
| Date First Available | November 11, 2022 |
| Manufacturer | ZLiT |
Kimberly L Illsley –
Direct fit to the XRT. Recommend a 3D printed cush drive.
Haus of Yablonski –
X series needs this item, it should have come with it. Still don’t know what the small squishy oring is really for but sometimes I put it inside the cush drive to eliminate slop.
Kimberly L Illsley –
Must have part if.you plant on bashing your truck or car very hard. It’s a direct fit for the xmaxx and adds plenty of extra support.
Chad –
i was almost convinced that this was not going to work in my Xmaxx, because me being me the smart time saver was determined to install this without removing the pinion or loosening the motor, i must have fought this for an hour right into dark thirty (past rc bedtime here in the sticks) then it accrued to me if i took off the pinion it would go right in and it would have if i didn’t fill my grub screw with super hard allan wrench end (love that when it happens) then i fought it for another hour before it donned on me i could loosen the motor luckily got all four screws loose without breaking poor alan anymore and all went together extremely easily. i love the extra support that should have been done at factory in the first place but hey you need to save as much money as possible at the expense of your customers right? this is america after all. don’t be like me and rush RC it will always bite you in the worst places arrrgh. (crying)