- Package Dimensions: 2.5 L x 3.0 H x 2.5 W (inches)
- Package Weight : 0.34 pounds
- Country of Origin : United States
- Part number: FP10003


Frete Grátis em todo o BrasilProduto Original Importado dos EUA
Delphi FP10003 Fuel Injection Pressure Regulator
*$697.60
Informação adicional
Manufacturer | Delphi |
---|---|
Brand | Delphi |
Model | Fuel Injection Pressure Regulator |
Item Weight | 1.6 ounces |
Product Dimensions | 2.5 x 2.5 x 3 inches |
Country of Origin | USA |
Item model number | FP10003 |
Exterior | Machined |
Manufacturer Part Number | FP10003 |
OEM Part Number | 5G1038, 5G1047, PR106, PR110, PR114, 217-361, 217-364, 217-366, 217-368, 217-369, 22849, 23064, 24030, 255-1044, 17107010, 17107485, 17107490, 17112273, 17112276, 17112324, 17112475, 17112994, 17091218 |
Date First Available | November 24, 2005 |
Terry s –
I put it on my car but my car still wouldn’t start the part was the right one for just the wrong thing to make it run but I will always shop at Amazon
Kelceygerm-01 –
Van has had stalling issue for years, finally I installed this. As long as I leave a certain vaccuum line off in vicinity the van will keep running with a rough idle, once I hook up this one vaccuum line the van surges, then dies.
RONALD TOWNSEND –
worked great.
TMH –
Installed on 1993 Corvette w/LT1 engine. On cold days, 60F and below, car would not start for 3 to 5 seconds of running the starter. Needing longer starter run time. Sometimes would take two attempts before starting. Car would have rich fuel smell, but would run normally after that.
Installed new Fuel Pressure Regulator. Now I turn the key, listen for the fuel pump to run for 2 seconds and shutoff, and then start the car. It starts immediately.
Travis Harner –
Great product replaced it thinking it was defective it turns out it was my new fuel pump by dilphin FE0114 not putting out the right gph.
JD –
Easy to install, fits and is doing the job
Amazon Customer –
Works just like the original. Direct bolt on.
billr –
it works good but it did not cure my problem
Paul C. Simcock –
Solid construction for first class aftermarket part.
Raul G –
I have a 97 Lotus Esprit. The forums indicate that the fuel pressure regulator is the same used in a Corvette from the 96 model year. The hard pipe on the regulator is a bit longer than what was on my car but it fit correctly.
The fuel connections to the rail, fit fine and the car ran with no leaks.