Frete Grátis em todos os produtos
- SOLID BATTERY TERMINAL: made of durable brass and electroplated with copper, which is rust and corrosion resistant, for safety use. With bright metallic color for easy daily check. With a long bolt for convenience
- WIDELY APPLICATION: apply to the battery has side post terminal with 3/8’’ hole. Also used for electrical equipment. DC 12V-24V system, 250A continuous and 750A momentary at DC 12V. CZC AUTO blade switch is suitable for car, boat, truck, vehicle, RV, ATV and etc.
- EASY TO INSTALL & USE: assemble the battery shut off switch to the negative cable. Turns power on and off by just lifting the lever up or down, on/off 2 position
- NO MORE DRAINED BATTERY: batteries that are empty and not charged for a long time will shorten the life causing you to replace it. This battery cutoff blade type switch allows you to eliminate any unwanted parasitic power draw from the battery
- WARRANTY: CZC AUTO offer 30-day money-back for any reason, 12-month warranty for quality-related issues. PlEASE NOTE: Any problem in using our side post battery terminal negative disconnect switch, simply contact us, your problem will be solved within 24 HOURS
OPTIMA Batteries High Performance D75/25 YellowTop Dual Purpose Sealed AGM Car, Truck and SUV Battery, 620 CCA, Dual Terminal, Maintenance Free, Versitile Mounting
*$3,874.90
BC Easy 4 US, Intelligent 4 Steps trickle Charger,Float Charger, Battery maintainer for All 12V Lead Acid Batteries of Cars, Motorcycles and ATV. Also for Deep Cycle Batteries....
*$636.40
Frete Grátis em todo o BrasilProduto Original Importado dos EUA
CZC AUTO Side Post Battery Disconnect Switch Solid Brass Knife Blade Master Switch 12V-24V Knife Power Cutoff Isolator for Car Marine Boat RV ATV, Horizontal
*$301.00
Informação adicional
| Operation Mode | Off |
|---|---|
| Current Rating | 250 Amps |
| Operating Voltage | 24 Volts |
| Contact Type | Normally Open |
| Connector Type | Blade Terminal |
| Brand | CZC AUTO |
| Terminal | Blade |
| Circuit Type | 1-way |
| Mounting Type | Surface Mount |
| Actuator Type | Rotary |
| Switch Type Kill Switch | Switch Type Kill Switch |
Nassio’s Best –
Working perfectly easy install
Seahawks4life –
Prevent my battery from discharging
CC –
I wanted a shutoff switch for my riding lawn mower. I suspect there might be a parasitic leak or something draining the battery. The two bolts that come with the switch are huge. It will not fit a small battery. I had to use a drill bit, yes that’s right, a drill bit to make the hole bigger on the positive terminal. I was then able to screw the bolts in. Another problem was how the bolts were different sizes for each other. They are not the same meaning you can’t switch the bolts to the other hole. One bolt is slightly bigger in width and longer. I made it work but 4 stars because this switch is too big and the bolts too.
CC –
Because my lawn tractor sits idle for months, its battery would often be dead in the spring, just when I needed it again. While I could simply disconnect the negative cable from the battery during the off season, this cutoff switch proved to be the perfect solution. I did have to make a slight modification, however. One of the holes in the switch is threaded for a 3/8-inch bolt, and the switch comes with two 3/8″ bolts. But the hole in my battery terminal as well as the negative cable were slightly smaller. I solved that by purchasing a 5/16″ x 1″ stainless steel bolt, 2 SS washers, and a SS nut (and a second 5/16″x3/4″ bolt, nut, and washer to attach the negative cable). It then took just a few minutes to install the cutoff switch, which is now firmly attached to the battery and works perfectly.
cory –
I was surprised when I opened the box and there was a screw and Allen wrench in the box. Then one side of the switch fell off. Apparently, the person responsible for assembling the switch was in a hurry and only did half a job. I screwed the brass connector to the crossbar and then used the Allen wrench and my nut driver to tighten the bolt that is the hinge for the disconnect blade. When I tried to put the disconnect on the battery, I noticed that the part that was loose and in the box did not get the flashing in the hole cleaned out so it wouldn’t fit over the battery terminal. I had to use a file to clean up the hole so that it would fit. Other than that, it is well made and works well on my battery.
Seahawks4life –
Great Quality, works well
Dave from San Antonio –
Could be a little cheaper
Rennie G. Gibson –
I really like this product. It is much bigger than It looked to be in the advertised picture. Works well.
Steven Scott –
Dual battery setup in 97 k1500 5.7 with meyer plow