- â¥â¥â¥ Widely Application: The 300A battery switch widely used for car, marine, boat, RV, camper, travel trailer, truck, ATV, UTV, battery banks and other devices.
- â¥â¥â¥ Premium Quality: The battery disconnect switch with Isolating ABS plastic shell and red copper plated silver inner core for maximum conductivity.
- â¥â¥â¥ Main Function: 3‑position 3‑stud dual‑circuit boat battery switch, switches a single battery to a single load group. Connect first and then break design, allowing to switch between battery packs without interrupting the power supply.
- â¥â¥â¥ High Performance: The marine battery switch is used to isolate and secure the electrical system, eliminate any power draw from the battery when vehicle or boat is not in use, disconnects the battery safely. Ideal for marine or RV applications.
- â¥â¥â¥ Simple Installation: Label with OFF‑1‑2, rotary actuator, IP66 function is ideal for replacement of old or damaging. Installed in the circuit, directly installed for use. Case design allows surface, front panel, or rear panel mounting.


Frete Grátis em todo o BrasilProduto Original Importado dos EUA
Akozon Battery Isolator, 300A Battery Switch 3 Position Dual Circuit Power Disconnect Switch Battery Cut Off Isolator for Marine Boat Car RV Battery Selector Switch
*$445.70
Informação adicional
Operation Mode | Off |
---|---|
Current Rating | 300 Amps |
Operating Voltage | 32 Volts |
Contact Type | Normally Closed |
Connector Type | Screw Terminal |
Brand | Akozon |
Terminal | Marine |
Circuit Type | 2-way |
Mounting Type | Panel Mount |
Actuator Type | Rotary |
Switch Type Rotary | Switch Type Rotary |
FRANCISCO RUIZ –
Très bien fait et solide
C. Clark –
Muy bien para poder seleccionar cualquiera de 2 baterÃas. Las conexiones firmes y buenas para soportar alto amperaje. Pagué sólo $104 por el mismo interruptor que Blue Sea vende 5 veces más caro.
C. Clark –
This battery isolator switch was exactly what I needed. Other isolators offer a 1, 2, off, and both selection. This isolator offers 1, 2, and off. Therefore, there is no worry of pulling volts/amps from both sources at once. It is either one or the other which is exactly what I needed. Also, the case that comes with it does not need to be installed which is exactly what I was also needing in order to flush mount the switch on a console. After wiring the switch up, it works exactly as intended. The switch mechanism seems taut and provides a good firm connection when switching. It is a bit pricey but it was what I needed to finish my diy project box. I would purchase again as it seems to be a well built device.