Frete Grátis em todos os produtos
- Compatible: used for side post terminal, battery side post with 3/8″ hole only, recommended to mount on NEGATIVE battery post, DC 12V-24V system, 200A continuous and 600A momentary at DC 12V, on/off 2 position.
- Convenience: knife blade type, easy to install & simple to use. Lift the knife, then power will cut. With 2 pairs 3/8″ side post battery terminal bolts (1 pairs short and 1 pairs long), 2 spacer and 2 washers.
- Heavy Duty: solid brass made, rust and corrosion resistant, durable made for safety use.
- Purpose: used for battery to isolate and secure the electrical system, eliminate any power draw from the battery when vehicle or boat is not in use, disconnects the battery safely.
- Compatible with GM side post batteries or other batteries which have a 3/8″ side post terminal, also used for electrical equipment.
8PCS Battery Terminal Anti Corrosion Washers, Battery Terminal Protector, 4 Red & 4 Green Battery Post Washer Fiber Washers for Protecting Battery Terminal, Universal Car...
*$189.60
Rome Tech Car Key Fob CR2032 Batteries Replacement Compatible with Buick Lacrosse 2005-2019, Regal 2011-2017, Buick Verano 2012-2017 - CR 2032 Buick Key Fob Battery - 1-Pack
*$274.20
Frete Grátis em todo o BrasilProduto Original Importado dos EUA
Side Post Knife Blade Master Switch, Ampper 12V / 24V Battery Disconnect Switch Isolator for Marine Car Boat RV ATV Vehicles (Kit)
*$385.00
Informação adicional
| Operation Mode | manual |
|---|---|
| Current Rating | 600 Amps |
| Operating Voltage | 12 Volts |
| Contact Type | Normally Open |
| Connector Type | Blade |
| Brand | Ampper |
| Terminal | Through Hole |
| Item dimensions L x W x H | 2.76 x 3.74 x 2.95 inches |
| Circuit Type | 1-way |
| Mounting Type | Side Post Mount |
| Actuator Type | Knife Blade |
| Contact Material | Brass |
| International Protection Rating | IP65 |
| Number of Positions | 2 |
| Control Method | Touch |
| Connectivity Protocol | X-10 |
| Color | Knife Blade |
| Wattage | 2.4E+3 |
| Manufacturer | Ampper |
| Model | Am-CBSKB0201 |
| Item Weight | 11 ounces |
| Product Dimensions | 2.76 x 3.74 x 2.95 inches |
| Is Discontinued By Manufacturer | No |
| Manufacturer Part Number | Am-CBSKB0201 |
| Special Features | eliminate any power draw from the battery when vehicle or boat is not in use, compatible with GM side post batteries, disconnects the battery safely, Used for car battery systems, isolate and secure the electrical system |
| Date First Available | December 18, 2016 |
MartinCountyRoadRunner –
If you have an older car, this is a great battery saver. Great value for the buck. Built strong, looks good.
Foxtrotterlady –
Shipped fast, works great.
Joe –
Product works as designed. I have a small battery compartment, but this fits well. Make sure to install with the contacts facing UP, to ensure the killswitch doesn’t open on a bump
Susan E. –
Our Chevy truck has an electrical problem that drains the battery if it sits for more than two days. This is keeping it from draining until we can get it to a repair shop to fix the problem. It was easy for me to install: “Here, hubby, put this on the battery.”. 🙂 It took him a bit of time to get it on but it is on and works great. Haven’t had a dead battery yet. Very easy to disconnect/connect with the flip of the “blade”. This item was hard to find locally because of the side terminals. We had been disconnecting the negative until this arrived. Something like this can also act as a theft deterrent, if it doesn’t start, they’re not going to hang around to figure out why.
Amazon Customer –
I tried a switch with a knob, but it was too wide for the space in a C5 Corvette. This blade switch is simple, well built and much narrower. It still took a little effort to install, but has solved my battery going dead problem when the car sits for weeks. If you are a C5 owner, once you cut the battery power, you will need to re-sync your FOBs no matter which switch you use. Very simple to do. Stand 6 feet behind your C5, press and hold lock and unlock at the same time. Hold both buttons until your C5 horn beeps. Repeat for the second Fob.
Jose antonio ferrer llamas –
رائع & رائع & رائع…&اروع….الخ
مريح وخاصة لمن يسافر كثير ويحتاج فصل البطاريات
وأيضاً لإعادة برمجة الكمبيوتر بعد الصيانة
الراحة مع هذا الجهاز
اشكر المصمم
Timothy A Musgrove –
This is solid and does its job, but the install was difficult because the hole in the copper housing that is meant to allow a 3/8-inch bolt to pass through, was too small due to having an imperfect shape. I had to get a drill bit, put inside the hole, and roll it around for several minutes to gradually enlarge the hole until it fit the bolt. (Deducting one star for this.)
After that was finally done, it was OK.
Happy with the final result, but two warnings:
Warning #1: it only comes with one bolt and there’s a good chance that you will need a different one. I ordered an inexpensive pack of assorted 3/8 battery bolts on Amazon — or they have the “kit” version of this product that comes with more bolts.
Warning #2: If like me you have very narrow clearance next to your side battery posts (mine are only 1 inch from the wall of the air intake filter), then you may have to remove the battery, put this switch on, and then lower the battery back into place.
This switch is pretty compact, so it will fit in a narrow gap, but the challenge is that the bolts wind up underneath the ledge of the switch — making it hard to get a wrench onto them from above to tighten them (the switch itself it in your way) — unless you heft the battery up first, then set it back down in the battery cradle *after* the switch is fully connected.
Amazon Customer –
Perfect.
MWJ –
Used on my six volt batteries of my motor home. I was very glad of the extra hardware, bolts and stuff included in the kit.
My review copied for the post type, not screw in.
I have bought several of these. Make sure you understand what side, positive or negative terminal you want these on and your clearance to operate the switch, some work sideways and some are up and down. I have two on my 1991 motor home, one for the starter battery and one for the two six volt system. I no longer have to worry about a ghost discharge. I have one on my sons 79 Camaro and one on his father in-laws show car. These were installed about six months ago, no problem. They look like they would be easy to clean if corrosion creeps in, time will tell. I see that some people have had problems with them breaking as they are installed around the battery post. To avoid this, IF your switch fits loose on the battery post, get a “Battery Terminal Post Adaptors Positive or Negative Sleeves” from you local auto store to fill in the gap
Wolf62 –
No es el que yo quería,no se puede poner en la batería del coche.